Panasonic AW-RP50 Manual

Also see for AW-RP50: Operating instructions Operating instructions Brochure & specs Brochure & specs Quick start guide

Panasonic AW-RP50 Manual Manual pdf 1 page image

★ By using AW-RP50 controller, you can switch the remote camera’s power supply from STANDBY mode (Power OFF)to POWER ON mode (Power ON), and vice versa.* Before you use AW-RP50 controller to control the remote camera’s power supply, you need to set up the connectionwith the camera in advance.For the connection setting-up procedure, please refer to the following Manual 【Controlling AW-HE40 Camera viaAW-RP50 Controller】.https://eww.pass.panasonic.co.jp/pro-av/support/content/faq/EN/remcam/1_.pdf<Note>・ Be careful with the Power ON/OFF operation described in this Manual because it can affect the camera’s pan-tilthead position at the time of turning the power on. (POWER ON Preset Function)For details, please refer to the following Manual 【Booting Up with Pan-Tilt Head in Specified Position】.https://eww.pass.panasonic.co.jp/pro-av/support/content/faq/EN/remcam/7_.pdf■ Turning ON/OFF Remote Cameras One by One＊ For switching the power supply mode of the remote camera (AW-HE40) which is assigned to [CAM1];1．Keep holding down LED button 1 at CAMERA STATUS/SELECTION area – (Fig.1-A). The selected camera’s namewill be displayed on the upper half, and its power status (POWER ON/POWER OFF) on the lower half of the LCDpanel – (Fig.2).2．While the LED button 1 is held down at CAMERA STATUS/SELECTION area, turn F2 dial – (Fig.1-B);(If you turn ON the camera,)Select “ON” – (Fig.2), and then press the F2 dial. The camera will switch over to POWER ON mode (Power ON).(If you turn OFF the camera,)Select “OFF” – (Fig.2), and then press the F2 dial. The camera will switch over to STANDBY mode (Power OFF).(Turning ON)(Turning OFF)Hold down Button 1Turn F2Press F2 to determineTurning ON/OFF Remote Camera Using AW-RP50Controller(Figure 1: AW-RP50 Control Panel)（A）（B）(Figure 2: AW-RP50 LCD Panel)CAM［1］ -HE40>POWER：OFF↓CAM［1］ -HE40>POWER：ON↓Press F2 to determineCAM［1］ -HE40>POWER：OFF↓

/ 3

Related manuals for Panasonic AW-RP50