9Install the boards in the computer.There are three boards to be installed:1. Video compression board (TARGA DV2000 board)2. SCSI board3. JOG board [AY-RP500 board (JOG board)]n Preparation1. Have a computer with Windows NT installed ready.Note: Windows NT must be installed on drive C:(IDE hard disk) which has been formatted usingthe NTFS file system.Note: Before installing Windows NT, decide whetherto use the entire area on the IDE hard disk asthe system area or to partition the drive into two,namely, the system drive and audio drive.When the entire drive is to be used as the sys-tem drive, format it using NTFS and then installWindows NT.When the entire drive is to be divided into twological drives, the MS-DOS FDISK command,etc. must be used to partition the disk beforeWindows NT is installed. Then proceed with theWindows NT installation.When the drive is to be partitioned, provide atleast 1 gigabyte of memory for the system drive(where Windows NT will be installed).2. Turn off the computer.3. Open the case of the computer. For details on howto do so, refer to the instruction manual that was pro-vided with the computer.4. Confirm which PCI slot (the white connector on themotherboard) the video card is installed in. If thevideo card is already in the PCI slot that is the far-thest from the CPU, you do not need to move thevideo card.5. In all other cases, move the video card according tothe procedure described in steps 6 through 9 below.6. Remove the screws that secure the cover for the PCIslot that is farthest from the CPU, and then removethat cover.7. Remove the screws that secure the cover for thevideo card, and then remove the video card.8. Plug the video card into the PCI slot that is farthestfrom the CPU, and secure the cover in place with thescrews.9. Store the screws and cover that were removed in asafe place.BOARD SETUPSCSI boardTARGA DV2000 boardCPUAY-RP500 board(JOG board)Video card