Panasonic AJ-HPD2500P Operating Instructions Manual

Also see for AJ-HPD2500E: Operating instructions

Contents

Panasonic AJ-HPD2500P Operating Instructions Manual Manual pdf 22 page image

22 Introduction: Control Reference GuideControl Reference Guide1. POWER switch (|/M)Turns the power on and off.Set the switch to “|” to turn it on.2. REMOTE button (REMOTE indicator)REMOTE buttonPress to enable control of this unit from an externaldevice.MODE (SHIFT+REMOTE) buttonPress the MODE and SHIFT buttons simultaneously,and the mode selection screen appears on the displaypanel.Select the USB device mode to connect the unit to aPC, the LAN mode to use the unit as a network server,the browser mode, or the AVCHD mode (available onlywhen an optional board is installed).➝Refer to “Using USB or eSATA Connectors” (page124)➝Refer to “Connecting This Unit to a Network” (page139)➝Refer to “Operating the AVCHD Thumbnail Screens”(page 161)3. Mode indicatorsA lamp corresponding to the currently selected modelights up.4. TCG switchAudio and Video Controller1 2 3 4 65 7 8 9 10 11 1225 272322 242617 1916 18 21 20151413REMOTEbutton is on:This unit can be controlled via the 9-pin remote, RS-232C, parallelconnector, or camera recorder.INTREGEN:Synchronizes the internal time codegenerator with the time code read from theP2 card.Use setup menu No. 505 (TCG REGEN) toselect whether to make TC or UB theREGEN.INTPRESET:Uses the internal time code generator ofthis unit. Settings can be preset on theoperation panel and the remote control.➝Refer to “Time Code, User Bit and CTL”(page 205)