|
30 Introduction: Control Reference Guide1. 4.3-inch Color LCD MonitorUse this monitor for thumbnail screens and otherscreens to facilitate video/audio searches and checks.2. SUPER switchSwitches the super output as follows.3. SD/SDHC Memory Card Slot / Access LampInsert the SD/SDHC memory card with the label sidefacing up and the end with the corner cut off facing in.Push in the card until it locks into place.To remove the card, first make sure that the greenlamp is on or orange lamp is not blinking, then push itin the direction of insertion to release the lock.➝When using an SD/SDHC memory card for AVCHDrecording and playback (option), refer to “Using SD/SDHC Memory Cards” (page 72).◆ NOTE: *1 memory cards>• Do not insert any cards other than SD/SDHC memorycards.• This unit uses only SD/SDHC memory cards that complywith the SD/SDHC specifications. Other memory cardssuch as MultiMediaCard*2 cannot be used. When using aminiSD or microSD card, be sure to use an adaptordedicated for use with the miniSD or microSD card.*1: The SDHC (SD High Capacity)/miniSDHC/microSDHCmemory card is a new standard, established by the SDCard Association in 2006, for large-scale memorycards with capacities above 2 GB.*2: MultiMediaCard (MMC) is a registered trademark ofInfineon Technologies AG.• Cards that will be used on this unit should also be formattedon this unit.• This unit supports the following SD and SDHC memorycard capacities.– SD: 8 MB to 2 GB– SDHC: 4 GB to 32 GB• For the latest information not available in the OperatingInstructions, visit the P2 support desk at the following Websites.For English: http://pro-av.panasonic.net/➝When using an SD/SDHC memory card forAVCHD recording and playback (option), referalso to “Using SD/SDHC Memory Cards” (page72).4. P2 Card Access LEDsThese LEDs indicate P2 card status.➝Refer to “P2 card access LEDs and P2 card status”(page 42).Panel Control Unit and Card Slots1 2 3 4 65 4 65ON: Outputs superimposed data such as timecodes to the LCD monitor and the outputconnector selected in setup menu No.005(SUPER).OFF: Does not output any superimposedinformation.
PreviousNext |