Setup: Item Settings 177SetupThis menu allows you to set method for engaging search dial operations, maximum shuttle speed operation, maximum speedof FF and REW operation, NEXT and PREV seek operations, display of warning messages when REF.VIDEO is not connected,PLAY delay time, display of warnings when power is too low, voltage when the power supply is turned off.• XX indicates factory default settings.OPERATIONItem SettingSettings and brief function descriptionFRNo.SUPERDISP.FRNo.SUPERDISP.100 SEARCH ENA00000001DIALKEYSpecifies method for transferring to the search mode (search dial operation).0: Press the SEARCH button or turn the search dial to engage search dial operation.1: Press the SEARCH button to engage search dial operation.101 SHTL MAX00000001000200030004×8×16×32×60×100Sets the maximum shuttle speed operation.0: 8× normal speed1: 16× normal speed2: 32× normal speed3: 60× normal speed4: 100× normal speed102 FF.REW MAX0000000100020003×32×60×100SEEKSets the maximum speed of FF and REW operation.0: 32× normal speed1: 60× normal speed2: 100× normal speed3: Seek operation to start of clipNOTE:• When SEEK is selected, FF and REW operations for FF and REW commandstransferred via 9P and RS-232C are performed at 100× normal speed. Note that seekoperations initiated by the FF and REW commands via 9P behave differently whenORIG is set in setup menu No. 202 (ID SEL). The cursor moves to left or right inthumbnail screens.• The seek operation is available in playback mode.103 SEEK SEL00000001CLIPCLIP&TSpecifies where a NEXT (SHIFT+FF) and PREV (SHIFT+REW) seek operation moves to.0: The start of the clip1: The start of the clip or video text memoNOTE:This setting is not available during FF and REW operation.104 REF ALARM00000001OFFONSelects whether or not a warning should appear when REF.VIDEO is not connected.0: Displays no warning1: Flashes the STOP lamp to warn108 PLAY DELAY0000|00150|15Sets PLAY delay time in frame increments.147 WFM DISP000000010002OFFWAVEVECTORSelects wave form monitor (WFM) display mode.0: Not displayed1: Waveform display2: Vector displayNOTE:• Wave form is displayed on the output destination selected in setup menu No.005(SUPER).• Wave form is not output to the composite connector.• When wave form is output to the destination other than the LCD monitor,superimposed information cannot be displayed.• Wave form of the original signal is displayed on the LCD monitor. Wave form of thesignal adjusted by the encoder VR (setup menus No.662, No.663, No.664 (V LEVEL,C LEVEL, HUE/C PHASE)) is displayed on other destinations.
