For Long and Trouble-Free Operation: Error Messages 205For Long and Trouble-Free Operation• A warning message is displayed whenever a warning occurs.When no warnings have been detected, “NO WARNING” is displayed.• When multiple warnings occur, turn the search dial to check the descriptions of each warning.If “T&S&M” is selected in setup menu No. 006 (DISPLAY SEL), a message appears in the mode display whenever a warningor error occurs.WARNING Information DisplayMonitor display Description Deck operation Counter displayBUSYDisplayed while clip information is being read or when clip configuration haschanged. No operations can be performed while this display is on the screen.[Meaning]• A card has been inserted or removed• Updating is in progress• Recording post processing is in progress• Other causesOperation continues BUSYCANNOT A.DUBDisplayed when audio voice-over cannot be recorded on a P2 card.[Meaning]• An attempt was made to record on a card that could not be used.• An attempt was made to record when no card was inserted.Operation continues CANTADUBCANNOT LOOPRECAppears in LOOP REC mode when P2 card recording is not available.[Meaning]• An attempt was made to record to a write protected disk.• An attempt was made to record on a card with no free space available.• An attempt was made to record on a card that could not be used.• Card status changed during recording.• Recording was attempted when the unit was BUSY.STOP CANTLRECCANNOT PLAYDisplayed when playback was interrupted due to a clip error or other factor.[Meaning]• An attempt was made to play a clip when no clips were present.• An attempt was made to play back a card that cannot be used.• The card could not be played back or playback stopped for some other reason.• Playback was attempted when the unit was BUSY.STOP CANTPLAYCANNOT RECDisplayed when data cannot be recorded on a P2 card.[Meaning]• An attempt was made to record to a write protected disk.• An attempt was made to record data on a card with no more free memory spaceon it.• An attempt was made to record on a card with no free space available.• Card status changed during recording.• Recording was attempted when the unit was BUSY.• VFR recording started but no active frame data was input.STOP CANT RECCANNOT REC SDDisplayed when a memory card is protected, there is not enough space orrecording in PH/HA mode is not available.(When an AJ-YCX250G AVCHD codec board (optional) is installed.)Operation continues CANT RECCHECK SDDisplayed when a non-compatible SD memory card, non-standard managementinformation or mismatched thumbnail data was recognized.(When an AJ-YCX250G AVCHD codec board (optional) is installed.)Operation continues CHK SDINT SGDisplayed for the first two seconds when the REC button is pressed to enter theEE mode and the VIDEO IN (SHIFT + EDIT MODE) button or the AUDIO IN (SHIFT+ VIDEO) button is set to SG.Operation continues INT SGINVALID IN/OUTPOINTDisplayed when an attempt was made to set an IN or OUT point in a locationwhere such points cannot be set. Operation continues Counter valueINVALID TRACKSELECTDisplayed when no audio track is selected or 3 or more channels are selected ina voice-over recording on a P2 card.Only 2 channels can be recorded in a voice-over recording.Operation continues CANTADUB
