Chapter 5 Shooting — Shooting- 104 -Check videos recordedBy pressing either the USER button* assigned to [REC CHECK] or touching the USER button icon after recording, you can automatically play back thelast approximately 3 seconds of the clip you have just recorded.* [REC CHECK] is set in the button at the time of purchase.≥ Returns to recording standby after checking.@ NOTE0 REC check will not operate in following cases.j When the power is turned ON/OFFj When restartedj When the button is pressedj When the memory card is inserted/ejectedj When formatted the memory cardj When the button has been pressed to switch the card slot to be recorded toj When switched to [CARD READER MODE] or [SERVICE MODE]j When the [RECORDING] menu → [2 SLOTS FUNC.] → [SIMUL REC]/[BACKGR REC] is setj When the [RECORDING] menu → [REC FUNCTION] → [REC MODE] → [INTERVAL] is setj When either of the following settings are changed[SYSTEM] menu → [FREQUENCY][SYSTEM] menu → [FILE FORMAT][SYSTEM] menu → [REC FORMAT][RECORDING] menu → [2 SLOTS FUNC.]≥ Refer to page 46 for USER button settings.Selecting the resolution, codec, and frame rate for recording videoThe resolution, codec, and frame rate of the recording video can be selected.≥ [SYSTEM] menu → [FREQUENCY]: System frequency≥ [SYSTEM] menu → [FILE FORMAT]: File format for recording≥ [SYSTEM] menu → [REC FORMAT]: Sets the signal format and codec mode for recording.≥ [SYSTEM] menu → [SUPER SLOW]: Super slow recording settings∫ How to read a [REC FORMAT] settingThe item names for recording formats indicate the resolution, the frame rate, the codec mode, and the bit rate.(However, bit rate is not included with some file formats.)For example: When the recording format for file format [MOV] is [2160-59.94p/HEVC LongGOP 200M]≥ The resolutions that can be set with this unit are as follows:j 2160: UHD (3840×2610), 1080: FHD (1920×1080), 720: HD (1280×720)≥ Smoother motion picture can be recorded with the higher value for the frame rate. [i] and [p] of the frame rate means interlace and progressiverespectively.Interlace (interlacing scanning):Video signal that divides the effective scanning lines to half and send them alternativelyProgressive (progressive scanning):High density video signal sending the effective scanning lines simultaneously (It will be higher quality image than the interlace.)≥ The image quality gets higher the larger the bit rate number. However, this is not the case when the codec mode is [ALL-I]. (This is because thecompression method is different.)≥ When the codec mode is [ALL-I], recording is with ALL-Intra.In this method, compression is performed at the individual frame level, so the file size increases, but it is possible to reduce the degradation of imagequality during the editing process.≥ Depending on the file format settings and bit rate of the recording format, the required Speed Class for the memory cards will differ. Use the compatiblememory cards. For details, refer to “Speed Class during shooting” on page 35.A ResolutionB Frame rateC Codec modeD Average bit rate2160 - 59.94p / HEVC LongGOP 200M
