14 OEM4 Family Installation and Operation User Manual Rev 12NoticeNoticeThe following notices apply to ProPak-LB and ProPak-G2.FCC NOTICEThis equipment has been tested and found to comply with the radiated and conducted emission limitsfor a Class B digital device, for both CISPR 22 and Part 15 of the FCC rules. These limits aredesigned to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses, and can radiate radio frequency energy and, if not installed and usedin accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If thisequipment does cause harmful interference to radio or television reception, which can be determinedturning the equipment off and on, the user is encouraged to try to correct the interference by one ormore of the following measures:• Re-orient or relocate the receiving antenna• Increase the separation between the equipment and the receiver• Connect the equipment to an outlet on a circuit different from that to which thereceiver is connected• Consult the dealer or an experienced radio/TV technician for helpIMPORTANT: In order to maintain compliance with the limits of a Class B digital device, it isrequired to use properly shielded interface cables (such as Belden #9539 orequivalent) when using the serial data ports, and double-shielded cables (such asBelden #9945 or equivalent) when using the I/O strobe port.WARNING: Changes or modifications to this equipment not expressly approved by NovAtelInc. could result in violation of Part 15 of the FCC rules.CE NOTICEThe enclosures carry the CE mark.WARNING: This is a Class B product. In a domestic environment this product may cause radiointerference in which case the user may be required to take adequate measures.
