Troubleshooting Chapter 9OEM4 Family Installation and Operation User Manual Rev 12 107Table 21: Resolving an Error in the Receiver Status WordBit Set Action to Resolve0 Check the Error Word in the RXSTATUS log. See also Table 20, Resolvinga Receiver Error Word, on Page 106.1 Check temperature ranges in the ENVIRONMENTAL table sections ofAppendix A, Technical Specifications starting on Page 111.2 See Section 3.1.3, Power Supply Requirements, Page 29.3 See Section 3.1.1, Selecting a GPS Antenna, Page 28, Section 3.1.2,Choosing a Coaxial Cable, Page 29, Section 3.2.3, Connecting the Antennato the Receiver, Page 34, Section 3.3.5, External Antenna LNA Power(OEM4-G2 Only), Page 40 and Appendix E, TTFF and Satellite Acquisition,starting on Page 161.4567 See Section 4.1.1, Serial Port Default Settings, Page 42.89101114 Move the receiver away from any possible jamming sources.15 See Section 3.1.2, Choosing a Coaxial Cable, Page 29 and move thereceiver away from any possible jamming sources.16 Move the receiver away from any possible jamming sources.17 See Section 3.1.2, Choosing a Coaxial Cable, Page 29 and move thereceiver away from any possible jamming sources.18 None. Once enough time has passed for a valid almanac to be received, thisbit will be set to 0. See also Appendix E, TTFF and Satellite Acquisition,starting on Page 161.19 None. This bit only indicates if the receiver has calculated a position yet. Seealso Appendix E, TTFF and Satellite Acquisition, starting on Page 161.20 None. This bit is simply a status bit indicating if the receiverís position hasbeen manually fixed and does not represent a problem. Refer also to the FIXcommand in Volume 2 of this manual.Continued on Page 108
