NorthStar 961 Install Manual

Also see for 961: User manual Reference manual Reference manual

Contents

NorthStar 961 Install Manual Manual pdf 65 page image

SECTION THREE - Interfacing961/962 INSTALLATION MANUAL Revision A Page 55To change the PPNM settings:1. Press the %745142#& to highlight PULSES PER NAUTICAL MILE,PULSE TIME MINIMUM, or PULSE SEPARATION MINIMUM, then pressthe '&+6 key.2. Enter the desired parameters, then press the #%%'26 key (or press%#0%'. to leave the option unchanged).Using VGA outputThe 961/962XD supports an external VGA monitor output from thefemale 15-pin standard VGA video connector on the back of theprocessor (see Figure 4 on page 23). Conversion of the signal to an NTSCor PAL video output is possible using VGA converters. Use aVGA-to-NTSC/PAL converter that doesn’t require separate software. Thisshould be plug-and-play hardware for standard VGA video inputconversion, supporting frame buffering at 75-Hz refresh rate. Also,consider the requirements for power: A unit requiring a DC power sourceis less likely to cause interference.