NorthStar 961 Install Manual

Also see for 961: User manual Reference manual Reference manual

Contents

NorthStar 961 Install Manual Manual pdf 55 page image

SECTION THREE - Interfacing961/962 INSTALLATION MANUAL Revision A Page 45Figure 24: Port 1 output setup screenFor any special requirements, check the installation instructions of theequipment to which you’re interfacing. The Northstar factory settings willbe adequate for most peripheral equipment, but the options described inTable 6, “Port setup options,” on page 45, are available if needed.Table 6: Port setup optionsField Name Parameter OptionsFormat OUTPUT FORMAT(see below)choose OFF, 0180, 0183, 0183-R, CDX, or490 (only on the PORT 3 OUTPUT SETUPscreen if the echo sounder has beeninstalled)Talker ID NMEA 0183 Talker ID(see page 50)choose GP or II to make the unit look like aGPS receiver or an “integrated instrument”(II)Send Every OUTPUT RATE(see page 51)choose 1 to 199 seconds0183 Prec NMEA 0183 lat/lon precision(see page 50)choose hundredths of minutes, thousandthsof minutes, or ten-thousandths of minutes0183 Wpts NMEA 0183 waypoint ID as(see page 51)choose NAMES or NUMBERS for theidentifier of waypoints sent to the externaldevice0183 Sum NMEA 0183 checksums(see page 51)choose ON or OFF for compatibility withsome older devices0183 Baud NMEA 0183 baud rate The baud rate is fixed at 4800