975. Using On-Screen MenuSetting up the Projector for a Wireless LAN Connection (with the optional USB WirelessLAN Unit equipped) [WIRLESS LAN]Important• Consult with your network administrator about these settings.• When using a wireless LAN connection, attach the optional USB Wireless LAN to the projector. (→ page 115)[PROFILE] [DISABLE] Wireless LAN connection will be turned off[SIMPLE ACCESSPOINT]Set the projector for simple access point.Selecting [SIMPLE ACCESS POINT] will allow the projec-tor to create an infrastructure network. The IP address ofthe projector will be set automatically.Select "Obtain an IP Address Automatically" to set the IPaddress of a connected computer.[PROFILE 1] Up to two settings for the USB wireless LAN unit can bestored in memory of the projector. (→ page 48)To recall the settings from memory, select [PROFILE 1] or[PROFILE 2] from [PROFILE].[PROFILE 2][RECONNECT] Retry to connect the projector to a network. Try this if you have changed [PROFILE].When you connect with your computer to save your profile and select "Automatically connect when within range" fromthe Properties tab of Wireless Network in Windows for your selected profile, your wireless LAN will be accessed underthe following conditions:• at the time of turning on the computer or the projector• when the notebook type is within the range of the projector's wireless LAN can be achieved.Data transmission between wireless LAN and wired LAN is not possible.When the [SIMPLE ACCESS POINT] mode is used to send images, it is recommended to connect to only one com-puter.
