363. Convenient Features Using the Computer Cable (VGA) to Operate theProjector (Virtual Remote Tool)Using the utility software “Virtual Remote Tool” included on the companion NEC Projector CD-ROM, Virtual Remotescreen (or toolbar) can be displayed on your computer screen.This will help you perform operations such as projector’s power on or off and signal selection via the computer cable(VGA), serial cable, or LAN connection. Only via serial or LAN connection it is also used to send an image to theprojector and register it as the logo data of the projector. After registering it, you can lock the logo to prevent it fromchanging.Control FunctionsPower On/Off, signal selection, picture freeze, picture mute, audio mute, Logo transfer to the projector, and remotecontrol operation on your PC.Virtual Remote screen ToolbarThis section provides an outline of preparation for use of Virtual Remote Tool.For information on how to use Virtual Remote Tool, see Help of Virtual Remote Tool. (→ page 41)Step 1: Install Virtual Remote Tool on the computer. (→ page 37)Step 2: Connect the projector to the computer. (→ page 39)Step 3: Start Virtual Remote Tool. (→ page 40)TIP:• Virtual Remote Tool can be used with a LAN and a serial connection. USB connection is not supported by Virtual Remote Tool.• For update information on Virtual Remote Tool, visit our website:http://www.nec-display.com/dl/en/index.html
