51. IntroductionRemoving and Attaching the Cable CoverAfter finishing connections, attach the supplied cable cover to properly hide the cables.CAUTION:• Be sure to tighten the screws after attaching the cable cover. Failure to do so may cause the cable cover to comeoff and fall, resulting in injury or damage to the cable cover.• Do not put bundled cables in the cable cover. Doing so may damage the power cord, resulting in a fire.• Do not hold the cable cover while moving the projector or do not apply excessive force to the cable cover. Doing somay damage the cable cover, resulting in injury.Removing the cable coverTool needed:• Phillips screwdriver (plus-head) about 9 cm/4 inches in length9 cm/4 inches1. Loosen the cable cover screws until the Phillips screw-driver goes into a freewheeling condition.• These screws remain to stay.2. Remove the cable cover.1 Push up the cable cover slightly and rotate it to release. Pull the cable cover while pushing and holding the arrowpartIf you find it to hard to release the cable cover, try holding itslightly up.12
