985. Using On-Screen MenuHints on How to Set Up LAN ConnectionTo set up the projector for a LAN connection:Access the HTTP server function to display the web browser (→ page 45) and select [NETWORK SETTINGS] →[SETTINGS] → [WIRELESS LAN] → [PROFILE 1] or [PROFILE 2].Two settings can be set for the USB Wireless LAN Unit.Next select [SETTINGS] for your selected profile, and set [ENABLE] or [DISABLE] for [DHCP], [IP ADDRESS],[SUBNET MASK], and [GATEWAY]. Last click [SAVE]. To reflect changes, click the [SETTING] tab and then click[APPLY]. (→ page 48)To recall LAN settings stored in the profile number:Use [PROFILE 1] or [PROFILE 2] set on the HTTP server, from the projector’ menu, select [SETUP] → [WIRE-LESS LAN] → [PROFILE] → [PROFILE 1] or [PROFILE 2]. Last select [YES] and press the ENTER button. (→page 97)To connect a DHCP server:From the projector menu, select [SETUP] → [WIRED LAN] → [SETTINGS] → [DHCP] → [ON] and press the ENTERbutton. To specify IP address without using the DHCP server, use the HTTP server function. (→ page 96)To set only for wireless LAN (NETWORK TYPE and WEP/WPA):Access the HTTP server function to display the web browser (→ page 45) and select [NETWORK SETTINGS] →[SETTINGS] → [WIRELESS LAN] → [PROFILE 1] or [PROFILE 2].Make necessary settings for [SETTINGS] and click [SAVE].From the projector menu, select [SETUP] → [WIRELESS LAN] → [PROFILE] → [PROFILE 1] or [PROFILE 2].To select an SSID:Access the HTTP server function to display the web browser (→ page 45) and select [NETWORK SETTINGS] →[SETTINGS] → [WIRELESS LAN] → [CONNECTION] → [SITE SURVEY] and select the ID.If you do not use [SITE SURVEY], type the SSID in [CONNECTION]. (→ page 48)To receive lamp replacement time or error messages via e-mail:Access the HTTP server function to display the web browser (→ page 45) and select [NETWORK SETTINGS] →[ALERT MAIL], and set [SENDER’S ADDRESS], [SMTP SERVER NAME], and [RECIPIENT’S ADDRESS]. Last,click [SAVE]. (→ page 50)
