41. Introduction Part Names of the ProjectorTop and Screen Side of ProjectorControls(→ page 7)Filter Cover/Intake Vent/Filter(→ page 118, 125)Spacer (Left/Right)To fine-adjust the height of the rearfoot, remove the spacer and rotatethe rear foot to the desired height.(→ page 19)Projection WindowFocus Ring(→ page 18)Tilt Foot(→ page 19)Built-in Security Slot ( )*Lamp Cover(→ page 123)Security chain openingAttach an anti-theft device.The security chain opening acceptssecurity wires or chains up to 0.18inch/4.6 mm in diameter.* This security slot supports the MicroSaver® Security System.Monaural Speaker (20 W)Terminal Panel (→ page 8)AC InputConnect the supplied power cord’sthree-pin plug here, and plug theother end into an active wall outlet.(→ page 13)Remote Sensor(→ page 10)Screw Hole for Cable Cover (Left/Right)(→ page 6)Terminal Panel Side of ProjectorIntake Vent/Filter(→ page 118, 125)Exhaust Vent
