NEC MultiSync VT440 User Manual

Also see for MultiSync VT440: Installation data Specifications Service manual User manual

NEC MultiSync VT440 User Manual Manual pdf 18 page image

E–17PC CONTROL S-VIDEO VIDEOINOUTOUTINRGB OUTPUTAUDIORGB INPUTWiring DiagramOptional Component V cableTo video, S-video, and audioinputs on the projector.Pin adapter for Macintosh (supplied)Signal cable (supplied)To mini D-Sub 15-pin connector on theprojector. It is recommended that youuse a commercially available distributionamplifier if connecting a signal cablelonger than the supplied cable.IBM VGA or Compatibles(Desktop type or notebook type)Macintosh or Compatibles(Desktop type or notebook type)Document CameraDVD Player (with component output)VCR, DVD Player or LaserDisc PlayerNOTE: When using with a notebook PC, be sure to connect between the projector and the notebook PCbefore turning on the power to the notebook PC. In most cases signal cannot be output from RGB outputunless the notebook PC is turned on after connecting with the projector.NOTE:* If the screen goes blank while using your remote control, it may be the result of the computer’s screen-saver or power management software.* If you accidentally hit the POWER button on the remote control, wait 30 seconds and then press thePOWER button again to resume.NOTE: If using video, S-video, or audio cables, the cables should be 3 m (9.8 feet) or shorter.MonitorSpeaker System