NEC MultiSync VT440 User Manual

Also see for MultiSync VT440: Installation data Specifications Service manual User manual

NEC MultiSync VT440 User Manual Manual pdf 13 page image

E–12Remote Control Features1 Source ButtonPress to select a video source.2 Auto Adjust ButtonUse this button to adjust Position-H/V and Pixel Clock/Phase foran optimal picture. Some signals may not be displayed correctly,or in some cases it may take some time for a source to switch be-tween sources.3 Menu ButtonDisplays the menu.4 Select ( ) / Volume (+) (–) Buttons: Use these buttons to select the menu of the item you wishto adjust. : Use these buttons to change the level of a selected menuitem.A press of the button executes the selection. When no menusappear, these buttons work as a volume control.When the pointer is displayed, these buttons move thepointer.5 Enter ButtonUse this button to enter your menu selection.6 Cancel ButtonPress this button to exit “Menus”. Press this button to return theadjustments to the last condition while you are in the adjustmentor setting menu.7 Magnify ButtonUse the (+) or (–) button to adjust the image size up to 400%.When the Pointer is displayed, the magnified image is displayed atthe center of the Pointer. When the Pointer is not displayed, themagnified image is displayed at the center of the screen.When the image is magnified, the pointer is changed to the magni-fying icon.8 Pointer ButtonPress this button to display one of the eight pointers; press again tohide the pointer. You can move your pointer icon to the area youwant on the screen using the Select button.9 Picture Mute ButtonThis button turns off the image and sound for a short period oftime. Press again to restore the image and sound.10 Help ButtonProvides information about operation and adjustment proceduresor the set information for the current menu or adjustment duringmenu operation. This also displays information how to use the Help.11 Power ButtonIf power is applied, you can use this button to turn your projectoron and off.NOTE: To turn off the projector, press and hold the POWER but-ton for a minimum of two seconds.12 Infrared TransmitterDirect the remote control toward the remote sensor on the projec-tor cabinet.Remote Control Precautions• Handle the remote control carefully.• If the remote control gets wet, wipe it dry immediately.• Avoid excessive heat and humidity.• Do not place the battery upside down.NOTE: Before you use the card remote control for the first time, besure to remove the insulation tape from the card remote control.* Keep the coin cell battery out of reach of children so as not toallow them to swallow the cell battery.CAUTION:Danger of explosion if battery is incorrectly replaced.Replace only with the same or equivalent type recommended bythe manufacturer.Dispose of used batteries according to your local regulations.Remote ControlSELECTPOINTERVol.–Vol.+POWERHELPRD-366EPIC.MUTEMAGNIFYSOURCE AUTOADJ.MENUENTE RCANCEL1357102468911NOTE: Remove the transparent insulation tape before use. Seepage E-34 for battery installation.MnO2-LiCELL3VOLTSJAPANHCR202512