E – 33PC CONTROL REMOTE2OUT OUTIN INOperating Multiple Projector with Remote ControlYou can operate multiple projectors with the same remote control in wireless operation.To do so:1. Select [Advanced Menu]→[Projector Options]→[Setup]→[Page 6]→[Projector ID] and assign an ID number toeach projector. See also page E-49.2. On the remote control specify the ID number of the projector to be adjusted. Press and hold the CTL and pressMENU (ADDRESS) button to enter the ID number.You can operate the projector assigned the same ID number as the remote control.Projector ID= 01 Projector ID= 02 Projector ID= 03Remote Address = 03You can daisy-chain multiple projectors and operate them separately with the same remote control in wired operation.To do so:1) Use the remote control cable to connect the REMOTE 2 Output of one projector to the REMOTE 2 Input of the nextprojector until all the projectors are connected. Only one remote control cable is supplied with each projector.2) Specify a unique projector ID for each projector.3) Specify the same remote address as the projector ID to be adjusted.NOTE: Specifying "None" for projector ID allows you to operate multiple projectors concurrently. However, some projectors may notsynchronize to the other projectors.Remote Address = 03To REMOTE 2 INProjector ID= 02 Projector ID= 03Projector ID= 01From REMOTE 2 OUTTo REMOTE 2 IN
