E – 32When used in stand alone operation.Pin No.1451034,8,12,11SHORT/OPENSHORTOPENSHORTOPENSHORTOPENSHORTOPENFUNCTIONExternal control mode ONExternal control mode OFFPOWER ONPOWER OFFPICTURE MUTE ONPICTURE MUTE OFFMUTE SOUND ONMUTE SOUND OFF* When the combinations other than specified in the above table are selected, the input will be forcefullyswitched to RGB 1.* The term “SHORT” means to connect with pin 15* When in the external control mode, the POWER, Source/Alphanumeric, PICTURE MUTE and SOUND MUTEbuttons on the remote control will not function.* When the External control mode is set to ON, the following settings are not effective: Timer, Auto Start, PowerManagement, Power Confirmation, Default Source Select.NOTE: Pin 13 is the external remote signal terminal. The projector can be controlled by the same format signal as thesupplied remote control from the external controller regardless of setting on Pin 14.NOTE: When turning off the power to the projector using the external control, do not disconnect the plug from the poweroutlet. These procedures are to protect your projector and the connected equipment.11pinOPENOPENOPENOPENOPENOPENSHORTSHORTSHORTSHORTSHORTSHORT12pinOPENOPENOPENSHORTSHORTSHORTOPENOPENOPENOPENSHORTSHORT8pinOPENOPENSHORTOPENSHORTSHORTOPENOPENSHORTSHORTOPENOPEN4pinOPENSHORTOPENSHORTOPENSHORTOPENSHORTOPENSHORTOPENSHORTRGB 1VIDEO 1S-VIDEORGB 2VIDEO 2RGB1 (S-VIDEO)DVI (DIGITAL)PC CARD VIEWERDVI (ANALOG)RGB 1 (VIDEO)RGB 2 (S-VIDEO)RGB 2 (VIDEO)
