E – 28REMOTE 1PC CONTROL REMOTE2SC, TRIGGEROUT OUTIN INRGB 2RGB 1VIDEO 1VIDEO 2S VIDEO AUDIO OUTR/Cr G/Y B/CbVH/HVMONITOR OUTL/MONO R L/MONO RL/MONO R L/MONO RWhen Used with One Switcher (ISS-6020/ISS-6020G)Up to 10 input signals can be accepted when the projector is connected to one Switcher. Using the projector withthe Switcher allows easy adjustment and signal selection.ISS-6020Personal computerVCRTo REMOTE1To RGBHV outputOptional control cable 15p-15p(CTL-6010)To audio inputAudio system• Select [Advanced Menu] → [Projector Options] → [Switcher Control] → [SW1 Level]. See page E-49 for the information in detail.• For more information on the Switcher, refer to the user’s manual accompanying the ISS-6020/ISS-6020G Switcher.• All cables mentioned above are sold separately.• The RGB2 terminal will not work with the Switcher Control function.To use the projector with the Switcher ISS-6020 in the Switcher Control mode,* When connecting with the VIDEO INPUT MODULE (6020-VID), set the VIDEO MODE select switch (S3001) to "8". The VIDEO MODE selectswitch is located on the VIDEO INPUT MODULE (6020-VID).NOTE: While in the Switcher Control mode, a video standard is selected at the projector.* If you set the VIDEO MODE select switch (S3001) to "8" with the QUAD DECODER installed in the Switcher ISS-6020, the image will not bedisplayed correctly.In that case, first remove the QUAD DECODER from the Switcher ISS-6020.For more details, contact your dealer.VCRPersonal computerTo audio outputTo slotBNC25 coaxial cable
