8-32Removing PCI ModuleFollow the procedure below to remove the PCI module.96. Stop the PCI module you want to remove.To this end, use the ft server utility of the NEC ESMPRO Agent installed to your server orthe Data Viewer of the NEC ESMPRO Manager.For more information, see "NEC ESMPRO Agent and Manager" - "Maintenance of NECExpress5800/ft series" in Chapter 5.NEC ESMPRO ManagerSelect [FTServer] → [PCI Module] → [PCI Module(to be removed)] → [Maintenance] → [BringUp/Bring Down] → [Bring Down].ft server utilitySelect [ft server] → [PCI Module] → [PCI Module(to be removed)] → [PCI Module Start/Stop] →[Stop].After the CPU enters into off-line status, the status LEDs of the PCI board and PCImodule will change as follows.PCI board slot status LEDs (all of them): OffPCI moduleFail LED: RedState LED: Off97. Unlock the front bezel with the security key and open it.Unlock the front bezel with the security key and remove the upper and lower panels.98. Disconnect the PCI module’s network cable and cables connected to the options.99. Loosen the setscrew securing the PCI module’s release lever.
