Chapter 4. General checkoutAttentionThe drives in the computer you are servicing might have been rearranged or the drive startup sequencechanged. Be extremely careful during write operations such as copying, saving, or formatting. Data orprograms can be overwritten if you select an incorrect drive.General error messages appear if a problem or conflict is found by an application program, the operatingsystem, or both. For an explanation of these messages, refer to the information supplied with that softwarepackage.Before replacing any FRUs, ensure that the latest level of BIOS is installed on the system. A down-level BIOSmight cause false errors and unnecessary replacement of the system board. For more information on how todetermine and obtain the latest level BIOS, see “BIOS levels” on page 243.Use the following procedure to help determine the cause of the problem:1. Power-off the computer and all external devices.2. Check all cables and power cords.3. Set all display controls to the middle position.4. Power-on all external devices.5. Power-on the computer.• Look for displayed error codes• Listen for beep codes• Look for readable instructions or a main menu on the display.If you did not receive the correct response, proceed to step 6 on page 35.If you do receive the correct response, proceed to step 7 on page 35.6. Look at the following conditions and follow the instructions:• If you hear beep codes during POST, go to “Beep symptoms” on page 63.• If the computer displays a POST error, go to “POST error codes” on page 64.• If the computer hangs and no error is displayed, continue at step 7 on page 35.7. Run the Diagnostic programs. See “Diagnostics” on page 55.• If you receive an error, replace the part that the diagnostic program calls out.• If the test stops and you cannot continue, replace the last device tested.Problem determination tipsDue to the variety of hardware and software combinations that can be encountered, use the followinginformation to assist you in problem determination. If possible, have this information available whenrequesting assistance from Service Support and Engineering functions.• Machine type and model• Processor or hard disk drive upgrades• Failure symptom– Do diagnostics indicate a failure?– What, when, where, single, or multiple systems?– Is the failure repeatable?© Copyright Lenovo 2013 35
