Kärcher HD 6/15-4 Service Manual

Also see for HD 6/15-4: Operating instructions Manual Original instructions Manual Manual

Kärcher HD 6/15-4 Service Manual Manual pdf 26 page image

26 English 5.906-565.0 Rev. 00 (12/12) Squeeze out the crankshaft in small steps. Be-tween every step, ensure that the piston rods arenot jammed or damaged by the crankshaft. Insert a suitable pipe section, e.g. 50x2x250 mm. Squeeze out the ball bearing and dispose of.CautionRisk of damage for the ball bearing. Choose the di-ameter of the pressing mandrel so that the press-inforce acts on the outer ring of the ball bearing. Press a new ball bearing into the crankshaft cas-ing. Pull the piston rod with the piston out of the crank-shaft casing.CautionRisk of damage for the gasket seat. Carefully use ascrewdriver when dismantling the gasket. Push the oil seal out of the crankshaft casing fromthe inside to the outside.or Lever out the outer oil seal from the cylinder headside.7.16.4Dismantling the crankshaft7.16.5Dismantling the oil seals