Kärcher HD 6/15-4 Service Manual

Also see for HD 6/15-4: Operating instructions Manual Original instructions Manual Manual

Kärcher HD 6/15-4 Service Manual Manual pdf 19 page image

English 5.906-565.0 Rev. 00 (12/12) 19 Push the sealing ring onto the installation mandrel(special tool). Place the installation sleeve on the cylinder head. Push the sealing ring through the installationsleeve (special tool) into the cylinder head usingthe installation mandrel. Lightly grease the sealing ring inside (grease6.288-079.0). Place the disc inside the brass disc. Insert both discs of the high pressure gasket pack-age in the cylinder head together. Centre the cylinder head on the pistons and pushit up to the crankshaft casing in one go.Note:If the cylinder head is pulled back during installation(e.g. because it was jammed during installation),there is a risk that the gasket packages depacketizeand are no longer seated correctly when pushed to-gether again. Screw in the cylinder head studs and tighten themcrosswise (torque 20...25 Nm).7.8.3 Installing the cylinder head