JVC KW-AVX706 Instructions Manual

Also see for EXAD KW-AVX706: Instruction manual Installation & connection manual Instructions Instructions Installation & connection manual

ENGLISHSETTINGS43Menu items Selectable settings, [reference page]SoundFader/Balance Adjust fader—speaker output balance between the front andrear speakers.• Upmost—front only• Downmost—rear onlyWhen using a two-speaker system, set the fader to the center(00).Adjust balance—speaker output balance between the left andright speakers.• Leftmost—left only• Rightmost—right onlyVolume Adjust Adjust and store auto-adjustment volume level for eachsource, comparing to the FM volume level. The volume levelwill automatically increase or decrease when you change thesource.• –12 to +12; Initial 00Subwoofer Adjust the settings below in the submenu:• Phase: Subwoofer phase. Select either “Normal” or“Reverse,” which reproduces a better sound.• Level*11: Subwoofer output level. Level: –6 to +8; Initial 0High Pass Filter Through: Select when the subwoofer is not connected.On: Select when the subwoofer is connected.Crossover Adjust the crossover frequency between the front/rearspeakers and the subwoofer.80Hz, 120Hz, 150HzAmplifier Gain You can change the maximum volume level of this receiver.Off: Deactivates the built-in amplifier.Low Power: VOL 00 to 30 (Select this if the maximumpower of the speakers is less than 50 W)High Power: VOL 00 to 50Rear Speaker*12 You can activate/deactivate the rear speakers.Off, OnMode*13 Mono Only for FM. (Off, On), ☞ [10]DX / Local Only for FM. (DX, Local), ☞ [11]SSM Only for FM. ☞ [11]*11 This subwoofer level setting take effects only when surround is deactivated (☞ also page 41).*12 Functions only when Dual Zone is activated.*13 Items listed under vary among the playback sources.Adjusts faderAdjust balance