Page 222 Troubleshooting TipsBeaming problemsI tried to do a wirelessHotSync operation, butit did not completesuccessfully.(continued)Check the following on your communicator:n Confirm that you are inside a coverage area, and that the signalis strong.n Make sure the dialing instruction dials the correct phone number.n If you need to dial an outside line prefix, make sure you selectedthe Dial Prefix option on your communicator and entered thecorrect code.n If the you have call waiting, make sure you selected the Disablecall waiting check box and entered the correct code in the PhoneSetup dialog box. See page 202 for details.n Make sure the connection is clear. Using a noisy connection caninterrupt communications.Problem SolutionI cannot beam data toanother IR-equipped PalmOS device.n Confirm that your communicator and the other device arebetween ten centimeters (approximately 4") and onemeter (approximately 39") apart, and that the pathbetween the two devices is clear of obstacles. Beamingdistance to other Palm OS devices may be different.n Check the General Preferences screen and make surethe Beam Receive setting is on.n Move your communicator closer to the receiving device.n Move your communicator farther away from the receivingdevice.n Angle the sides of the two devices towards each other.n Perform a soft reset. See page 210 for details.When someone beams datato my communicator, I get amessage telling me it is out ofmemory.n Your communicator requires at least twice the amount ofmemory available as the data you are receiving. Forexample, if you are receiving a 30K application, you musthave at least 60K free.n Perform a soft reset. See page 210 for details.
