48Chapter 4: Installing Componentswww.gateway.com■ If cable-select is available (drive assignments will be marked on thecable), the IDE cable assigns the master/slave positions to the drivesit connects. You can override these assignments using the jumpers onthe drives.■ If cable-select is not available and only one drive is attached to an IDEcontroller cable, configure the drive as master if it is a CD drive. Iftwo drives of any type are attached to the cable, configure one asmaster and one as slave.■ You may need to configure the drives you install using the BIOS Setuputility. Press F2 at startup to open the BIOS Setup utility.Installing a media driveUse these instructions to install or replace a diskette, CD, or tape drive.To install a 5.25-inch drive:1 Follow the instructions in “Preventing static electricity discharge” onpage 41.2 Follow the instructions in “Opening the server case” on page 42.3 If you are replacing a drive, go to Step 7.- OR -
