11Mounting your server into a cabinetwww.gateway.comMounting your server into acabinetThe cabinet mounting hardware included with your server should be used withstandard 4-post cabinets that have front and back vertical posts. The L-shapedcabinet mounting brackets can be used for mid-mounting on a 2-post cabinet,but that procedure is not covered here. If your cabinet is a different type, obtainmounting hardware from the cabinet manufacturer.Rackmount kit contents:■ Server rails (2)■ Cabinet rails (2)■ L brackets (2, not used for this type of installation)■ Fastener pack (1)■ Small screws (4, #6-32 × 3/16-inch)■ Medium screws (8, #10-32 × ½-inch)■ Large screws (2, #10-32 × 7/8-inch)■ Handle spacers (2)■ Nut bars (4)■ Disk guides (2)Warning Before attaching cabinet accessories, make sure thatthe server is turned off and all power cords areunplugged.Warning The cabinet must provide sufficient airflow to the frontof the server to maintain proper cooling. It must alsoinclude ventilation sufficient to exhaust a maximum of1200 BTUs per hour for this server.
