107Troubleshootingwww.gateway.comYour server does not recognize a SCSI drive■ Make sure that the SCSI controller is enabled in the BIOS Setup utility.■ Reinstall the device driver. For instructions, see Using Your Server CompanionCD.■ Change the drive’s SCSI address to one that is not being used by your server.For more information about SCSI device configurations, see your drive’sdocumentation.■ Run SCSI Verify in the SCSI BIOS. For more information about the SCSIBIOS, see the SCSI controller’s documentation.■ Turn off your server, then remove all hard drives and push them in againto make sure the drives are seated correctly. For instructions, see “Installinga hard drive” on page 54.The master boot record is corrupted■ In a Windows network operating system, repair the master boot recordusing FDISK.To repair the master boot record:■ At a DOS command prompt, type fdisk/mbr, then press E NTER.InternetSee also Modem.You cannot connect to the Internet■ Make sure that your account with your Internet Service Provider (ISP) isset up correctly. Contact your ISP technical support for help.■ Make sure that you do not have a problem with your modem. Forinstructions, see “Modem (telephone dial-up)” on page 108.
