Garmin GNC 420AW Pilot's Manual

Also see for GDL 69: Pilot's guide addendum Pilot's guide addendum Activation Instructions Activation Instructions Pilot's guide addendum

Contents

Garmin GNC 420AW Pilot's Manual Manual pdf 75 page image

69Part SixGTS 800 InterfaceConfiguring Traffic Data on the Map PageTraffic is only displayed on the Map Page if aircraftheading data is available. When heading is not avail-able, Traffic Advisories are displayed as non-bearingbanners on the Map Page.Selections for configuring traffic data aremade from the Map Setup Menu on the MapPage.To configure traffic on the Map Page:1. Turn the small right knob to select the MapPage.2. Press MENU to display the Page Menu. Turnthe small right knob to select “Setup Map?”and press ENT.3. The flashing cursor highlights the GROUP field.Turn the small right knob to select Traffic andpress ENT.4. Turn the large right knob to select the desiredTraffic Mode option. Turn the small right knobto select the desired option and press ENT.Repeat the step for Traffic Symbol and TrafficLabel.5. Return to the Map Page by pressing CLR.Traffic mode allows the operator to choose which traf-fic is displayed (all traffic, traffic and proximity advisories,or traffic advisories only). The traffic symbol is the symbolused to depict the type of traffic:NOTE: Proximity Advisories (PA) are displayed as solidwhite diamonds (may be configured as cyan). The GTS800 shows these PAs as “other” (hollow diamonds).PAs are defined as traffic within the 6.0-NM range, with± 1200 feet of altitude separation, and not a traffic advi-sory (TA).The traffic label is the altitude separation above orbelow the symbol and the vertical speed sense arrow tothe right of the symbol. From the Map Page, you candisplay traffic in a thumbnail format in any of the topthree data fields (top four fields on the 500W Series)on the right side of the Map Page.When a Traffic Advisory is active, the “Traffic” banner is dis-played in the lower right corner of the Map Page.To display Thumbnail Traffic on the Map Page1. Turn the small right knob to select the MapPage.2. Press MENU to display the Page Menu.3. Turn the small right knob to select “ChangeFields?” and press ENT.4. Select one of the top three fields (top fourfields on the 500W Series). Select TRFC fromthe Select Field Type List and press ENT. Notethat the thumbnail range defaults to 6 NM andcannot be changed.190-00356-30 Rev H

/ 78

Related manuals for Garmin GDL 69