Chapter 4. ConfigurationGFK-2224Q January 2017 43Configuring Embedded Ethernet for Ethernet Global Data (EGD)This section describes how to configure the parameters of an RX3i embedded PACSystems Ethernet Interface.See also Configuring Ethernet Global Data (page 54) for a fuller discussion.In the event the CPU will be used to produce or consume Ethernet Global Data (EGD), right click on the deviceicon and, using the “Add Component” drop-down list, select “Ethernet Global Data”, as shown in Figure 19:Figure 20: Adding Ethernet Global Data (EGD) to the ConfigurationOnce the EGD component has been added, it is possible to define the EGD data to be produced (Figure 20) andthe EGD data to be consumed (Figure 21) by the embedded Ethernet Interface, per the following screen-shots.Figure 21: Defining EGD Produced Data Exchange
