Appendix A. Configuring Advanced User ParametersGFK-2224Q January 2017 255ARP Parameters (task f) Default Rangefflush Interval in seconds at which to flush the ARP cache 600 (10 minutes) 0 – 604800 (93A80H)Ethernet Global Data Parameters27 (task g) Default Rangegctl_port UDP port for EGD control messages 7937 (1f01H) 1 – 65535 (ffffH)Only the gdata_portand gXX_udpparameters mayshare the same UDPport number. All otherUDP port numberparameters in the AUPfile must use uniqueport numbers.gdata_port UDP port for point-to-point (unicast) EGD messages 18246 (4746H) 1 – 65535 (ffffH)Only the gdata_portand gXX_udpparameters mayshare the same UDPport number. All otherUDP port numberparameters in the AUPfile must use uniqueport numbers.gbcast_ttl IP time-to-live for global broadcast messages (hopcount)1 (1H) 0 – 255 (00ffH)gucast_ttl IP time-to-live for point-to-point (unicast) messages(hop count)16 (10H) 0 – 255 (00ffH)gp_phase Startup delay time in ms for successive producedexchanges0 (0H) 0 – 65535 (ffffH)gcmd_pri EGD command processing priority relative to dataproduction.0 = EGD commands have lower priority.1 = EGD commands have equal priority.2 = EGD commands have higher priority.0 (0H) 0, 1, 2gc_accel Enable consumed exchange acceleration.0= Acceleration disabled; 1= Acceleration enabled.1 (1H) 0, 127 Effective with RX3i CPE310/CPE305 Firmware Release 8.30, all EGD commands are supported exceptgcmd_pri and gc_accel.
