14 49-85215USING THE OVEN: Oven Controls Oven ControlsTo operate the oven:1. Ensure gas is available at the range by lighting anysurface burner and turning it off again.2. Push and turn knob to the PILOT position.3. Push in completely and hold for 10 seconds, thenrelease (Holding in on the oven control knob for lessthan 10 seconds at the PILOT position may cause theoven burner not to light.)4. Push and turn to the temperature you want.5. Check for oven burner flame by opening the oven doorand looking through the hole at the front of the ovenbottom.If no sparking noise is heard when the oven temperatureknob is pushed in at the PILOT position, replace the batterywith a fresh 9V alkaline battery. Battery compartment islocated behind the broil door.6. Turn the control knob to OFF when finished baking.To Adjust the Thermostat (on models with an OVEN TEMP Knob)1. Pull the OVEN TEMP knob off the range and lookat the back side. To make an adjustment, loosen(approximately one turn), but do not completelyremove, the two screws on the back of the knob.2. With the back of the knob facing you, hold the outeredge of the knob with one hand and turn the front ofthe knob with the other hand.To increase the oven temperature, move the top screwtoward the right. You’ll hear a click for each notch youmove the knob.To decrease the oven temperature, move the topscrew toward the left.Each click will change the oven temperatureapproximately 10°F. (Range is plus or minus 60°Ffrom the arrow.) We suggest that you make theadjustment one click from the original setting andcheck oven performance before making any additionaladjustments.3. After the adjustment is made, retighten screws so theyare snug, but be careful not to overtighten.4. Replace the knob, matching the flat area of the knobto the shaft, and check performance.Lighting the Oven with a MatchThe oven of a battery-powered cordless range may be litwith a match and operated normally, even if the battery istoo weak to activate the spark system. Follow these stepsto match-light the oven burner:1. Remove the oven door, oven racks, and oven bottom.To remove oven bottom, remove two 1/4” hex headscrews at the rear of the oven.2. Locate the oven burner pilot at the left rear of the ovenburner.3. Hold a lit match to the oven burner pilot. Turn theoven control knob to the PILOT position and push incompletely.4. After pilot lights, continue to hold in firmly on the knobfor 10 seconds before releasing.5. Pilot should remain lit. If not, repeat steps 3 and 4.6. Replace oven bottom, racks, and oven door.7. Turn knob to the desired temperature setting. Oven willoperate normally.Turn oven control knob to OFF when finished baking.LOOSENSCREWSTOROTATEMAKECOOLERMAK EHOTT E RBack of OVEN TEMP knob(knob appearance may vary)PILOT