Fujitsu TeamPoS 2000 Installation And Maintenance Manual

7.11 Memory (DIMM or SDRAM)Use this procedure to replace memory or to add memory (upgrade) These instructionsrefer to the memory as DIMM, but the instructions apply to both DIMM and SDRAMmemory. Note that the A and H motherboards have 3 memory slots and the Mmotherboard has 2 memory slots.1. Remove the AC power cable.2. Remove the front cover (see secton 5.1.1).3. Remove the side cover (left) (see section 5.1.2).4. Pull the main board out completely, and place on flat surface.5. If memory is being replaced, push both DIMM (or SDRAM) levers at both endsdown towards the outside to remove the memory unit from the main board.6. If memory is being added, push the two levers down out and down as far as they willgo7-20 Rev 3.0 90000291TeamPoS 2000 MAINTENANCE MANUALCaution: To prevent electric shock, confirm that the AC cable is removed fromthe AC outlet anytime the covers are removed. Be sure to observe allESD precautions and power off procedures.