Fujitsu TeamPoS 2000 Installation And Maintenance Manual

7. Route the cable as shown. Putting the heat shrinksection in the connector opening will make it easierto install the display connector cover.8. Install connector cover by inserting the right side tab(as viewed from the back of the display) into thedisplay and then pushing down on the left side.9. Install the tilter part by first inserting the tilter tabs (3) into the display slots and thensecuring with a screw.10. Insert the tilter into the pole and push it until itlocks into place.11. Mount display pole in the display pole stand.Align the opening of the pole (tape side) withthe insert on the LCD stand back-end and pushwith sufficient pressure to lock the pole inplace. Do not remove the tape.90000291 Rev 3.0 5-65TeamPoS 2000 MAINTENANCE MANUALNote: The customer display can be mounted so that it is to the left, right or center of thepole, depending upon which display slots are selected.