Fujitsu TeamPoS 2000 Installation And Maintenance Manual

4. Thread the connecting wire of the MSR through theshim up to the black insulation.5. Connect the small white connector to the side ofthe LCD. The connector has a key so it will onlyfit one way.6. Slide the metal brace through the shim and into theside of the back panel. There are three grooves thatact as guides. It only fits one way.Push the shim and MSR brace into the LCD untilthey fit snuggly against the D15. The 3 screwholes in the brace will line up with the three screwholes on the back of the D15. Use the 3 screwsprovided with the MSR kit to secure the MSR.7. Reattach the access panel by inserting the tabs atthe left first and then snapping the right tabs intoplace.After installation power up and test MSR with testcard.5.9.7.4 SmartPoSKeyPad InstallationA 5 x 8 keypad can be installed on any of the D15 models:1. Place the D15 face down on a clean surface, making sure there is nothing that willdamage the screen. The bottom edge of the unit should be nearest to you.Remove the left-side gray access cover and the contrasting end cap. (See MSRinstallation)5-50 Rev 3.0 90000291TeamPoS 2000 MAINTENANCE MANUAL