65[Description]• This parameter sets whether or not to perform the RCJ(Cold junction compensation) for the thermocouple in-put. Use the factory default setting (ON: performs theRCJ) under normal conditions.ON: Performs the RCJ (Cold junction compensation).OFF: Does not perform the RCJ (Cold junction com-pensation).RCJ (Cold junction compensation) (Setting range: ON/OFF)[Setting example] Changing the RCJ (Cold junction compensation) from ON to OFFPress and hold theSEL key for five seconds.will be displayed on the PV display.Press the key to display .Press theSEL key once.The current setting ( ) flashes on the SV display.Press the or keys to display .Press theSEL key once. will stop flashing and will be registered for . After that, thecontroller will operate with the RCJ (Cold junction compensation) being .If you want to display the operation status, press and hold theSEL key for two seconds.Operating procedureDisplay1.2.3.4.5.6.• Set this parameter to OFF under the conditions that theRCJ is not needed, such as when the RCJ is performedoutside of the PXR or when the temperature deviationsare recorded.www. .com information@itm.com1.800.561.8187
