42[Description]• This parameter is used for selecting the number of decimalpoint positions for the PV (Measured value).Decimal point position (Settings: 0 / 1 / 2)Related parameters: (page 40)(page 40)[Setting example] Changing the decimal point position setting from 0 to 1Press and hold theSEL key for three seconds.will be displayed on the PV display.Press the key to display .Press theSEL key once.The current setting ( ) flashes on the SV display.Press the key to display .Press theSEL key once. will stop flashing and will be registered for . After that, thecontroller will operate with one decimal point position displayed.If you want to display the operation status, press and hold theSEL key for two seconds.Operating procedureDisplay1.2.3.4.5.6.“0” (No digit after decimal point)“1” (1 digit after decimal point)“2” (2 digit after decimal point. This is valid only for the voltage and current inputs)www. .com information@itm.com1.800.561.8187
