17Local/remote operation setting (Setting range: LoCL/rEM) (Option)[Description]• This parameter is used to switch between local and re-mote operations.[Setting example] Switching to remote operationPress and hold theSEL key for one second.will be displayed on the PV display section.Press the keys to display .Press theSEL key once.The current setting ( ) in the SV display section flickers.Press the keys to display .Press theSEL key once. Flickering stops and the operation is switched to remote.To display the operation status, press and hold theSEL key for two seconds.Operating procedureDisplay1.2.4.6.Set value OperationPerforms local operation.Performs remote operation.(“ ” and the set value (SV) are displayedalternately in the SV display section on thefront face while in remote operation.)Related parameters: (page 75)(page 75)(page 76)(page 77)* Local operation: Control by SV set by the keys on thefront face, ramp-soak operation, SVselection determined by digital input,and SV setting via communication* Remote operation: Control by SV determined by RemoteSV input3.5.www. .com information@itm.com1.800.561.8187
