11Stopping or interrupting a self-cleaning cycle 91To start the delayed self-clean cycle 92To set the control for the self-cleaning cycle tostart at a delayed time and shut off automatically 92When the self-clean cycle is completed 92Adjusting oven temperature 93To adjust oven temperature 93Failure modes 93How the PRC Glass touch electronic oven control works 94Capacitance touch glass 94Preheat 94Bake 94Timed bake 94Convection bake 94Convection roast 94Broil 94Clean 95Calibration 95To check oven calibration 95To change the calibration 95To adjust the oven temperature lower 95Troubleshooting 95F1 code 95F3 code 95F9 code 96Control will not program 96Time bake does not operate 96Convection bake 96Fan motor does not operate 96Convection element does not heat 96Control does not operate in preheat 96Blank display 96Bake element does not heat 96Broil element does not heat 96Oven door does not lock when the ovenis programmed for clean 97Oven door locks but the oven does not heat 97Door latch is partly closed with door open 97Sample schematic for PRC Glass touch control system 98Warmer drawer 99To set the warmer drawer thermostat control 99How the warmer drawer circuit works 99Troubleshooting 99If the element does not heat 99If the element heats during preheat, then staysoff until the temperature drops to about 130° F 100If the element does not cycle off 100If the warmer drawer is slow preheating 100If the warmer drawer heats, but theindicator light does not glow 100SECTION E - 30” DISASSEMBLY AND REPLACEMENT OF PARTS 101 - 122Top trim on backguard area 101Removing the 15 amp fuse 101Removing the fluorescent lamp starter 101To roll the control mounting panel forward 101Removing the 120 volt outlet 101Removing the oven light or fluorescent switch 102
