Managing and Viewing LogsD-Link Unified Wired and Wireless Access SystemOct. 2015 Page 119D-Link UWS User ManualHosts ConfigurationUse the Host Configuration page to configure remote logging hosts where the switch can send logs. To enableremote logging, see “Syslog Configuration” on page 123.To access the Host Configuration page, click LAN > Administration > Log > Host Configuration in the navigationtree.Figure 46 shows the Host Configuration page in its default state, before any logging hosts are added.Figure 46: Host ConfigurationAfter you add a logging host, the screen displays additional fields, as Figure 47 showsFigure 47: Host Configuration with Logging HostAdding a Remote Logging HostUse the following procedures to add, configure, or delete a remote logging host.1. From the Host field, select Add to add a new host, or select the IP address of an existing host to configurethe host.If you are adding a new host, enter the IP address of the host in the IP Address field and click Submit. Thescreen refreshes, and additional fields appear.2. In the Port field, type the port number on the remote host to which logs should be sent.3. Select the severity level of the logs to send to the remote host.4. Click Submit to apply the changes to the system.
