Selecting the Copy Paper Size (Paper Select) 1-17Basic Copying1Selecting the Copy Paper Size (Paper Select)You can set the machine to automatically select the paper size, or you can specify the papersize for a copy job.NOTE• When copying an original onto the same size paper at a 100% copy ratio, the periphery of theoriginal may be cut slightly on the copy. For details of the size of the non-image areas, see theReference Guide.• If you select the Entire Image mode, the copied image is automatically reduced slightly based on thepaper size and the image size. As a result, the entire original image is reproduced on paper withoutbeing trimmed. (See ‘Slightly Reducing Images to Prevent the Original from Being Trimmed (EntireImage),’ on p. 1-33.)• For instructions on setting paper in the stack bypass, see the Reference Guide.Automatic Paper Selection (Auto Paper Selection)The machine automatically selects copy paper.IMPORTANT• When the machine is operating in the Automatic Paper Selection mode, you cannot use the AutoCopy Ratio, XY Auto Copy Ratio, Rotate Collating, Rotate Grouping, Saddle Stitch, Booklet, ImageCombination, Image Separation, or Image Repeat (Auto) modes.• When the machine is operating in the Different Size Originals mode in combination with the Shiftmode or the Cover/Sheet Insertion mode, you cannot use the Automatic Paper Selection mode.• You cannot use the Automatic Paper Selection mode when copying the following types of originals.Copy these originals using the Manual Paper Selection mode.- Non-standard size originals- Highly transparent originals such as transparencies- Originals with an extremely dark background- Originals smaller than STMT in sizeNOTE• The default setting is “Auto.”• When the Drawer Eligibility for APS/ADS of the paper drawers in the Common Settings is set to “Off,”you can not make copies in the Automatic Paper Selection mode. (See the Reference Guide.)
