Canon imagePROGRAF iPF8300 Basic Guide No.2 Basic Manual

Also see for imagePROGRAF iPF8300: Brochure Troubleshooting guide Troubleshooting guide Brochure Setup guide

Contents

Canon imagePROGRAF iPF8300 Basic Guide No.2 Basic Manual Manual pdf 39 page image

39Error MessagesError Message Cause Corrective ActionThe print job received specifiesa type or width of paper that isnot compatible with borderlessprinting.Follow these steps to change the settings of the printjob to enable borderless printing.Borderless printng not possible.Press ▲ or ▼ to select Stop Printing, and thenpress the OK button.1.Make sure the correct printer driver for the printer isselected and try printing again.2.For information on types of paper compatible withborderless printing, refer to the Paper ReferenceGuide.Select None when you have set Detect Mismatch onthe control panel to Warning.Press ▲ or ▼ to select Print With Border, andthen press the OK button to continue printing. Thedocument will be printed with a border.Press ▲ or ▼ to select Stop Printing, and then pressthe OK button to stop printing.Prepare for parts replacement. It is almost time to replaceconsumables for which service isrequired.You can continue to use the printer for some timeuntil Parts replacement time has passed. will bedisplayed.Contact your Canon dealer for assistance.(→"Types of Paper," User Manual)The loaded paper is a size notcompatible with borderlessprinting. Replace the paper with paper compatible forborderless printing as follows.Press ▲ or ▼ to select Print With Border, andthen press the OK button to continue printing. Thedocument will be printed with a border.Parts replacement time haspassed.It is past the recommended timeto replace consumables for whichservice is required.Contact your Canon dealer for assistance.Before borderless printing,move the blue platen switch.The blue Switch on the platen wasset to the side opposite ● when aborderless print job was received.Press ▲ or ▼ to select Change Paper, and thenpress the OK button to remove the roll.1.Replace the paper with paper compatible forborderless printing.2.(→ , Removing the Roll from the Printer)(→"Removing the Roll Holder from Rolls," UserManual)(→ , Attaching the Roll Holder to Rolls)(→ , Loading Rolls in the Printer)The printer now starts printing the print job.For information on types of paper compatible withborderless printing, refer to the Paper ReferenceGuide.(→"Types of Paper," User Manual)Before borderless printing, set the blue Switch on theplaten to the ● side.(→"Setting the Blue Switch on the Platen," UserManual)However, note that this error may cause paper jamsand affect the printing quality.