Canon imagePROGRAF iPF8300 Basic Guide No.2 Basic Manual

Also see for imagePROGRAF iPF8300: Brochure Troubleshooting guide Troubleshooting guide Brochure Setup guide

Contents

Canon imagePROGRAF iPF8300 Basic Guide No.2 Basic Manual Manual pdf 29 page image

29Always check the Adj. Priority values before using Auto(GenuinePpr) or Auto(OtherPaper).•Adjustment is not possible with Auto(GenuinePpr) and Auto(OtherPaper) when using highly transparent media.•If additional fine-tuning is necessary after Auto(GenuinePpr) and Auto(OtherPaper), execute Adj. Fine Feed.•This may take some time, depending on the type of paper.•Use paper of the same type and size for adjustment as you will use for printing.•Always make sure the loaded paper matches the type of paper specified in the settings. Adjustmentcannot be completed correctly unless the loaded paper matches the settings.•Use Adjust Length to ensure that lines in CAD drawings are printed at exactly the right length.•(→"Selecting a Feed Amount Adjustment Method (Feed Priority)," User Manual)In this case, use Manual adjustment.(→"Fine-Tuning the Paper Feed Amount (Adj. Fine Feed)," User Manual)(→ , If Line Length Does Not Match)(→"Manual Banding Adjustment (Adj. Quality)," User Manual)1Perform adjustment as follows.If printed images are affected by banding in different colors across the sheet, execute Adj. Quality for automaticadjustment of the paper feed amount.There are two modes of automatic adjustment to correct banding: Auto(GenuinePpr) and Auto(OtherPaper). Ineither mode, the printer prints and reads a test pattern for automatic adjustment of the feed amount.Items to Prepare Rolls•An unused roll at least 10 inches wideSheets•Auto(GenuinePpr): One sheet of unused paper, A4/Letter sizeAuto(OtherPaper): Two sheets of unused paper, A4/Letter size (or one sheet when using A2)If Banding OccursThis topic describes how to adjust the feed amount automatically.Load paper.(→ , Attaching the Roll Holder to Rolls)(→ , Loading Rolls in the Printer)(→ , Loading Sheets in the Printer)Use this mode with paper identified in the Paper Reference Guide. (→ , Types of Manuals)Use this mode with paper not in the Paper Reference Guide, or if Auto(GenuinePpr) does not eliminatebanding.Auto(GenuinePpr)•Auto(OtherPaper)•