Chapter 1515-31Bit 6 detailsSelect whether to enable the host machine to work as a USB storage device or not. If the host machine is plugged into a PC with this setting enabled, it allows userregistration data (user data and telephone registration data) to be imported and exported to and from the PC, except for the data embedded in the department man-agement information and user management IDs in the system management information.15.10 Registration of Accessories (ACC)15.10.1 Accessory Registration 0017-6178The table below gives summary description of the accessories available.15.11 License Management (LMS)15.11.1 Outline 0017-8537LMS (License Management Service)License Management System is to acquire a figure row from sending the information of the license certificate number, which is in the same package as optionproduct, machine serial number and the name of the main machine to the server that has a license issue function on the Internet.Option function will be able to be used by inputting the acquired figures from the main machine operation board through license registration screen in the usersmode.License option function is implemented on all the main system of the products, which is shipped from the factory, but it would not activate unless input operationhas been made through the license registration screen.Acquisition of the license key and registration of the device is basically done by the user. Detailed procedure is described in the users guide. However, as for ref-erence, summary of the procedure is mentioned below.(1) Access to LMS from the below URL and follow the direction on the screen to acquire the license key.URL for LMShttp://www.canon.com/lms/license/MEMO:To acquire the license key, 16 digit figures on the license access number certificate and the device serial number (for example: ABC01234), which the license isgoing to be installed is necessary.Device serial number will indicate on "Serial Number" when pressing the counter confirmation key on the main machine.(2) Copy the license key of 24 digit figures, which is indicated on the WEB browser to the designated column on license access number certificate.Reconfirm that there is no miss-copy of the 24 digit figures. Explain to the user that license access number certificate should be kept with care.(3) Input the copy of the license key from; user mode > system management setting> license registration and press enter. The license key will be registered andfunction will activate.If the function do not activate, error message will indicate. Confirm the points below due to contents of the error message."Value of the license key is incorrect. Confirm license key">> Using the license key, which was issued to another device?>> Incorrect license key was input?>> Proper license key used?5 Not used - -6 Imports and exports user information via USB. Enable Disable7 Not used - -Item Explanation#ACC CARD Card reader installation settingEnter a card number to use.(0 to 9999. One hundred cards are registered with the department ID beginning from the input card number in sequence.)*1:1,000 cards if option ROM is mounted.When a card number is entered, the following kinds of management information are initialized:- Card name (department ID), beginning from the input card number.- Password associated with the cardCC-SPSW Control card I/F support settingSet whether to support the control card I/F (CC-V) or not.0: Do not support.1: Support.COIN Coin vendor changeSet the control card set display appearing on the operator station for vendor use.0: Control card use1: Coin vendor useCONTROL Set the PDL printer output control where the control card I/F (CC-V) is supported.0: Enable printing without a card mounted.1: Enable printing with a card mounted in position.Bit Function 1 0
