Chapter 1414-114.1 Error Code Table14.1.1 List of Error Codes 0017-6036T-14-1Error Code Detail Code Error Name/Explanation of ErrorE000 0000 Fixing temperature abnormal riseE001 0000 Fixing unit temperature rise detection (by main thermistor)0001 Fixing unit temperature rise detection (by sub thermistor)E002 0000 Fixing unit temperature insufficient riseE003 0000 Low fixing temperature detection after standby (by main thermistor)0001 Low fixing temperature detection after standby (by sub thermistor)E007 0000 Fixing film rotation errorE010 0000 Main motor rotation errorE019 0001 Waste toner full detection0002 Waster toner full detection sensor failureE052 0000 Duplex unit connection errorE100 0000 BD cycle out of rangeE196 0001 Error on writing and readout ROM of image processor PCB (main ROM).0002 Error on writing and readout ROM of image processor PCB (option ROM).E197 0000 Erroneous communication with printer engineE261 0000 Zero-cross signal errorE500 0001 Finisher communication errorE520 0000 Offset errorE531 0000 Stapling errorE5400001 Paper surface not detected (standard tray)0002 Not moved within the specified time (standard tray)0003 Sensor not reached within 3 seconds (standard tray)0005 Encoder clock failure (standard tray)E5420001 Paper surface not detected (optional tray)0002 Not moved within the specified time (optional tray)0003 Sensor not reached within 3 seconds (optional tray)0005 Encoder clock failure (optional tray)E575 0000 Stack delivery errorE584 0000 Shutter failureE716 0000 Erroneous communication with optional cassetteE719 0000 Erroneous communication with card reader (serial communication)0002 Erroneous communication with coin vender (serial communication)E730 0000 Inside error of the image processor PCB (PDL system error)E733 0000 Erroneous communication between controller and printerE736 0000 CCU communication errorE739 0000 Erroneous communication between controller and network boardE7440001 Language file/boot ROM/USB memory error000200030004E805 0000 Fan failureE808 0000 Fixing drive circuit failure