Chapter 1515-2#TEST MODEMakes various status checks, such as contact sensor, sensor and print status.15.1.2 Using the Mode (Touch Panel Type) 0017-8509F-15-115.2 Default settings15.2.1 Service Mode Menus 0017-6051#SSSWNo. Initial setting FunctionSW01 00000000 error/copy controlSW02 not usedSW03 00000000 echo remedy settingSW04 10000000 communication fault remedy settingSW05 00000000 standard function (DIS signal) settingSW06 - SW11 not usedSW12 00000010 page timer settingSW13 00000000 meter/inch resolution settingSW14 00000001 inch/meter resolution settingSW15 - SW24 not usedSW25 00000000 report indication resolution settingSW26 - SW27 not usedSW28 00000000 V.8/V.34 protocol settingsSW29 not usedSW30 00000000(JPN)/00000011(EURO)/00000001(Other country/region)Assigning a New Dial Tone Detection MethodSW31- SW32 not usedSW33 00000000 counter function settings1) Selecting Service ModePress the Additionalfunctionskey, 2key, 8key, Additional functionskey sequentially.#SSSW# N U M E R I C P a r a m .# N U M E R I C P a r a m .2) Selecting a Menu ItemSelect the Menu item using the[left arrow]/[right arrow] on thetouch panel.3) Press [OK].5) Registering/Setting DataEnter data using the keypad,and then press [OK].6) Press the [Stop]/[Additionalfunctions]/[Reset] key to endthe service mode.# N U M E R I C P a r a m .# 3 NUMER I C P a r am.0 0 10 0 10 0 20 0 200104) Selecting a PrarameterSelect the Prarameter using the[left arrow]/[right arrow].1) Selecting Service ModePress the Additionalfunctionskey, 2key, 8key, Additional functionskey sequentially.#SSSW3) Selecting a Menu ItemPress [OK].2) Press [OK] on thetouch panel.5) Registering/Setting DataEnter data using the keypad,and press the [OK].6) Press the [Stop]/[Additionalfunctions]/[Reset] key to endthe service mode.0 3 34) Selecting a Bit SwitchSelect the bit using the[left arrow]/[right arrow] onthe touch panel.# S S S W# S S S W000000000000000000 0 3 3# S S S W 0000000000 3 3# S S S W 000000001