PlaybackE60a) Press the AUDIO MONITOR button to display“STEREO1”, “STEREO2”, and “MIX”, each inturn.• Your choice is selected a few seconds after youlast pressed the button.If you choose “MIX” you can go on to mix the balance.• Use the r / t cursor keys to choose the mix balance.(or the ST-1/ST-2 MIX BALANCE buttons on the remote control).Set the audio output in two main stages: (i) Selecting the audio mix(ii) Choosing the output channel(i) Selecting the audio mixWhen you play back a tape that was recorded in 12 bit mode, you can select the output:Stereo 1, Stereo 2, or a mixture of the two.• Audio from the 16 bit mode only contains stereo 1 sound and so you cannot/do not need to select theaudio mix. The same is true for the 12 bit stereo 1 mode, unless new sound has been added post-recording. Go directly to stage (ii).• You only need to release the fixed level (step 2) if your aim is to mix the balance.MIX SELECT••VARIABLESelecting the Audio OutputVLRSAUDIO 1L RAUDIOMONITORS TER EO 1 M I XS TER EO 21. Set the camera to VCR mode.2. Release the fixed level (for audio mixing only).(see p. 18)a) Open the VCR menu and point the arrow at MIX SELECT.b) Select the VARIABLE setting and close the menu.3. Choose the output.
