Preparation10EYou can slide the viewfinder unit along the bracketto a position that best suits you — for use witheither the left or right eye.1. Loosen the locking screw and slide theunit to the position you require along thebracket.2. Tighten the locking screw.3. Switch the eye cup around (if necessary).• Slide and hold the release lever on theunderside of the viewfinder and then twist theeye cup counter-clockwise (until the mark onthe eye cup lines up with the mark on theviewfinder) to allow you to remove it fromthe viewfinder. Replace, with the eye cupfacing the opposite direction, by lining up themarks and twisting the cup clockwise until itlocks into place.Adjusting for left eye/right eye operationAdjusting the Viewfinder UnitThe camera is supplied with the viewfinder unit and cable attached to the camera.• Check that the viewfinder cable is firmly attached to the camcorder.1, 2 3Right eye use Left eye use• Remove the protective rubber from around the locking screw.
